MF Series Laboratory muffle furnace

Muffle Furnace MF Series (Best Seller)

Laboratory chamber furnace, vertical lift door, works in continous at high temperature, modern lines

  • Temperatures 1.000 ºC – 1.200 ºC -1.300 ºC – 1400ºC
  • Vertical lift door
  • Let work 24/7 in continuous mode
  • 4 heating plates with Kanthal AF – APM
  • Low thermal mass insulation
  • Built with low density ceramic bricks and ceramic fiber
  • Double isolation chamber (Air chamber circulation)
  • Outside casing in metal sheet painted ( inox as optional)
  • Ventilated via rear by ceramic chimney
  • Ceramic tray included
  • Thermocouple type K or S
  • Compact and lightweight furnace
  • Easy to replace all the spare parts by the end user
  • Furnace control:
    • Under the furnace
    • Solid state relay
    • PAD Digital control. Microprocessor. Alarm.
  • Safety Shut-off
    • Thermocouple break shut-off
    • Turns off upon door opening
  • Manufactured under the CE
  • Accessories
    • Ceramic tray
    • Refractory steel tray
    • Smoke chimney
    • Forced smoke chimney
    • Security class II. Over-temperature protection (OTP)
    • Inlet gas entry
    • Flow meter box
    • Annealing Box
  • Control system
    • Ramp programmer up to 64 steps
    • Eurotherm EPC Series  + Data logger Itools sofware by Ethernet (Optional)
    • Eurotherm Nanodac Series  +Data logger and Itools sofware by Ethernet according AMS2750E and 21CFR Part 11 (Optional)


EN 196-2, 196-21, 459-2 Standards and is used to determine the loss on ignition of cement and lime; chloride, carbon dioxide, alkali content of cement.

Calcination, ashing, tempering, heating, general laboratory purpose

Data Sheets

Calcination, heat treatment in an oxidising atmosphere (air), applied to minerals and other solid materials to cause thermal decomposition.

Ashing is the process of heating combustible samples and then analysing the ash.

the residual ash comprises the inorganic, non-combustible compounds.

Annealing is a heat treatment process that alters the physical properties of a metal in order to increase its ductility and make it easier to work with.